29
6
MISFEED REMOVAL
When the misfeed ( ) indicator blinks or blinks in the display, the unit will
stop because of a misfeed.
1
Open the multi-bypass tray, and side cover, in that order.
To open the multi-bypass tray, see "The multi-bypass tray" (p.10). To open
the side cover, see "TONER CARTRIDGE REPLACEMENT" (p.22).
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If the misfeed ( ) indicator blinks, proceed to "A:
Misfeed in the paper feed area" (p.30).
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.30)
If paper is misfed here, proceed to "B:
Misfeed in the fusing area". (p.30)
If the misfed paper is seen from
this side, proceed to "C: Misfeed
in the transport area". (p.31)
To Next Page
Loading...
