Sharp AR-M256 Service Manual

AR-M256/M257/M258/M316/M317/M318/5625/5631 OTHERS 11 - 5
D. Network scanner function setting program
Default settings
Disable default setting changes ON / OFF∗ When the PCL printer expansion
board is installed or the model with
the board.
Interface settings Hexadecimal dump mode ON / OFF∗ When the PCL printer expansion
board is installed or the model with
the board.
I/O timeout 1 – 999 (Increment of 1sec.) 180 (sec.)∗
(60 (sec.)∗: When the PCL printer
expansion board is installed or the model
with the board.)
Parallel port emulation switching Auto∗ / PostScript (When the PS3
expansion kit is installed.) / PCL
When the PCL printer expansion
board is installed or the model with
the board.
USB port emulation switching Auto / PostScript (When the PS3 expansion
kit is installed.) / PCL∗
When the PCL printer expansion
board is installed or the model with
the board.
Network port emulation switching Auto∗ / PostScript (When the PS3
expansion kit is installed.) / PCL
When the PCL printer expansion
board is installed or the model with
the board.
Port switching method Switch at end of job∗ / Switch after I/O
timeout
When the PCL printer expansion
board is installed or the model with
the board.
Enable parallel port ON∗ / OFF When the PCL printer expansion
board is installed or the model with
the board.
Enable USB port ON∗ / OFF When the PCL printer expansion
board is installed or the model with
the board.
Enable network port ON∗ / OFF When the print server card
installed.
Enable ECP ON / OFF∗ When the PCL printer expansion
board is installed or the model with
the board.
Network settings
(When the print
server card
installed.)
IP address setting DHCP: ON∗ / OFF When the PCL printer expansion
board is installed or the model with
the board (Also displayed when the
print server card is not installed.)
To enable the changed setup, the
power must be rebooted.
Enable TCP/IP ON∗ / OFF To enable the changed setup, the
power must be rebooted.Enable NetWare ON∗ / OFF
Enable EtherTalk ON∗ / OFF
Enable NetBEUI ON∗ / OFF
Reset the NIC
—
When the PCL printer expansion
board is installed or the model with
the board (Also displayed when the
print server card is not installed.)To
enable the changed setup, the
power must be rebooted.
Initialize and/or
store settings
(When the PCL
printer expansion
board is installed
or the model with
the board.)
Restore factory default —
Store current configuration
—
Restore configuration
—
Reboot is required only when the
network setting is changed.
Key operator programs Set value (∗: Default value) Remarks
Key operator programs Set value (∗: Default value) Remarks
Scanner settings
(When the
scanner function is
valid.)
Initial file format
setting
File type PDF / TIFF∗
Compression mode No compression / MH (G3) / MMR (G4)∗
Pages per file ALL∗
Initial quality setting Original image type TEXT / TEXT/PHOTO∗ / PHOTO
Exposure
Auto∗ / Manual (1 / 2 / 3 / 4 / 5)
Initial resolution setting 200dpi / 300dpi∗ / 400dpi / 600dpi (400dpi: For China, Taiwan)
Default display settings Condition settings∗ / Address book /
Address book (ABC) / Address book
(Group)
The number of direct address/sender keys
displayed setting
6 / 8∗ / 12 (pcs.)

Sharp AR-M256 Specifications

General

Brand	Sharp
Model	AR-M256
Category	All in One Printer
Language	English