AR-M256/M257/M258/M316/M317/M318/5625/5631 SIMULATION 8 - 28
Operation/procedure
Input the set value with the 10-key and press the [START] key.
Note: Executable only with SRU (AR models).
Operation/procedure
Enter the set value with the 10-key, and press the [START] key.
Operation/procedure
When this setting is made, the image output direction in the staple
mode and that in the normal mode become the same. Therefore, the
user who uses printed paper (logo, house style, etc) need not change
the original direction in the staple mode. (When the finisher is used,
images are rotated 180 degrees in the staple mode.)
Enter the set value with the 10-key, and press the [START] key.
Note: Executable only when the finisher is installed.
Operation/procedure
Enter the set value with the 10-key, and press the [START] key.
Operation/procedure
Input the set value with the 10-key and press the [START] key.
• AR-M256/M257/M258/M316/M317/M318
• AR-5625/5631
26-36
Purpose Setting
Function
(Purpose)
Used to set whether the machine is stopped or not
when the maintenance counter life is expired.
Item Operation
Item Content Default
0STOP Stop
1
1 NON STOP Non stop
26-41
Purpose Setting
Function
(Purpose)
Used to set ON/OFF of the automatic magnification
ratio selection (AMS) when setting the binding function.
Item Operation
Item Content Default
0 OFF AMS is not set automatically. 1 (SUK, SEF,
SEEG, SEEG2)
0 (Others)
1ON
AMS is set automatically.
26-46
Purpose Setting
Function
(Purpose)
Used to set whether to meet with the output direction of
images regardless of the mode when installing the
finisher.
Item Operation
Item Content Default
0
OFF
No setting (The output image direction is
changed in the staple mode of the finisher.)
0
1
ON
Setting (The output image direction is the
same regardless of stapling or not.)
26-50
Purpose Setting
Function
(Purpose)
Used to set ON/OFF of the black and white reversion
function.
Item Operation
Item Content Default
0ON
Enable 1 (SUK)
0 (Others)
1OFF
Disable
26-57
Purpose Setting
Function (Purpose) Used to set the model code.
Item Operation
Item Default
1 AR-M256
1
2 AR-M257
3 AR-M258
4 AR-M317
5 AR-M316
6 AR-M318
7 AR-267FP
8 AR-317FP
9 AR-267FG
10 AR-317FG
11 AR-267S
12 AR-317G
13 AR-267G
14 AR-317S
Item Default
1 AR-5625
1
2 AR-5631
SIMULATION 26-57
SIMULATION 26-57
To Next Page
Loading...
