101
GRAPHING FUNCTIONS
When [Default] is selected in the graph
display mode, a graph is re-drawn according
to the default window data.
When [Square] is selected in the graph
display mode, a graph is re-drawn according
to the new window information.
When [Dec] is selected in the graph display
mode, a graph is re-drawn according to the
new window information.
When [Int] is selected in the graph display
mode, a graph is re-drawn according to the
new window information.
When [Stat] is selected in the graph display
mode, a graph is re-drawn according to the
new window information.
[5 Default] — To set the graphing function
to the standard display
settings (default settings).
• The default settings vary in
the four modes.
[6 Square] — To set the same scale for the
X and Y axes.
• The Y-axis scale is adjusted
according to the X-axis scale.
[7 Dec] — To set each screen dot to
“0.1”.
[8 Int] — To set each screen dot to “1”.
[9 Stat] — To display all points of
statistical data.
[B FACTOR] To adjust the X and Y axis zoom factors, and display the settings.
Key operations: Pressing B displays the following screen.
Display changes
®
→
• When the above screen (zoom factor input screen) appears, the cursor is located
over “ ” of “X
—
Fact”.
• Enter a numeric value for the X axis zoom factor, and press ®.
• The entered value is displayed at the lower right side of the “X
—
Fact =” indication.
The cursor moves to “Y”.
• Set the zoom factor for the Y axis.
• To exit from this screen, press Ï œ.
• The zoom factors set on this screen are used in the zoom in and out functions
described previously. A graph cannot be re-drawn by setting FACTOR only.
■
x
EL-9650-(04)En (079-134) 8/7/00, 9:08 PM101
To Next Page
Loading...
