20
CHAPTER 1
10. SET UP Menu
• SET UP is a function that sets input and display methods.
• Please select each method according to use.
• Be sure to set the SET UP mode according to desired calculations and graph
plotting since there may be differences in the results depending on the set conditions
of SET UP.
(1) Checking SET UP contents
Press
Ï
.
Contents displayed on the right side of the screen when
selecting [A] are the current settings.
* “A” is highlighted and current settings are displayed when
entering the SET UP mode. In this case, it is not necessary to
press
A
.
(2) SET UP menu
The above display will appear when
Ï
are pressed. Since item A of the main
menu is used for displaying the current settings, the menus that can be set are B
through G, with sub-menus for each. The functions of these are explained below.
[B DRG]: Used to set the angle unit (default setting: Rad)
[1 Deg]: Set to degree
[2 Rad]: Set to radian
[3 Grad]: Set to gradient
}
The relationships are:
EL-9650-(01)En (001-036) 8/1/00, 12:04 PM20
To Next Page
Loading...
