LIST FUNCTIONS
145
• A list is handled as numeric data containing multiple numeric values in parentheses.
• A list is normally used in equations and calculations.
The calculator has six registration areas, L1 to L6, as memory areas.
Additionally, all lists L1 to L6 are registered as one set of list data. Up to ten sets of
list data, L_Data 1 to L_Data 9, and L_Data 0 can be stored.
• To input data and create a list, select the general function calculation screen.
<Example>
Assume that the data 1, 3, 2, and 9 and the other data 5, 4, 6, and 3 exist. Store
both of the sets of data to L1 and L2, respectively.
1.
¬
Selects the general function screen and clears it.
2.
Ï
1
,
3
,
2
,
9
Ï
Puts one set of data in parentheses. A comma (,) must
be put between numeric values.
3. The data input is now completed. Next, to store the
above data to list L1, follow these steps.
To resister the data, use
Î
.
Stores the data to list L1.
Î
Ï
®
.
In the same manner, to create list L2, follow these
steps.
Ï
5
,
4
,
6
,
3
Ï
Î
Ï
®
• To specify the list number, press
Ï
(or
to
)
®
. The specified list is displayed on the
screen.
,,,
,,,
CHAPTER 6
LIST FUNCTIONS
EL-9650-(06)EN (145-156) 8/1/00, 9:03 AM145
To Next Page
Loading...
