105
GRAPHING FUNCTIONS
• Input a numeric value while the cursor is displayed and press ® to set it.
Rectangular coordinate system:
Xmin/Xmax: X-axis minimum and maximum values
Xscl: X-axis scale (Same contents apply to the Y-axis.)
Parametric coordinate system:
The values below are applied to this coordinate system
in addition to those in the rectangular coordinate system.
Tmin/Tmax: T minimum and maximum values
Tstep: Cursor pointer step value during tracing
Polar coordinate system:
The values below are applied to this coordinate system
in addition to those in the rectangular coordinate system.
θmin/θmax: θ (angle) minimum and maximum values
θstep: Cursor pointer step value during tracing
Sequential coordinate system:
The values below are applied to this coordinate system
in addition to those in the rectangular coordinate system.
n
Min/
n
Max Maximum and minimum values of the
sequential variable (
n
)
PlotStart/PlotStep: Start and step values of the variable
(
n
) for drawing graph
EL-9650-(04)En (079-134) 8/7/00, 9:08 PM105
To Next Page
Loading...
