114
CHAPTER 4
[E G_DATA]
[1 Sto GD]
Saves the graph data. The graph data can be saved to any of ten memory spaces
G_Data 1 to G_Data 9, and G_Data 0. Graph data which can be saved are the
equation data (in all rectangular, polar, parametric, and sequential coordinate
systems) and window settings.
If the memory was previously used, new data overwrites the old data.
Operation:
1. Press Ï
E1. The screen shown to the
right will appear, allowing you to input the memory
number where you wish to save the data.
2. Press 1 ®. Graph data is saved to G_Data 1. The
screen shown on the right will appear, showing that the
graph data has been saved to G_Data 1.
[2 Rcl GD]
Calls up the saved graph data.
Specify the graph data number to call up the graph which is already saved. (If the
graph data is called up, that graph data overwrites the graph screen and window
data currently displayed on the screen.)
If the graph database to be called up cannot be found, the relevant error message
will appear on the screen.
EL-9650-(04)En (079-134) 8/7/00, 9:08 PM114
To Next Page
Loading...
