262
CHAPTER 13
* Please be aware that if there are existing data on the receiving side, the existing data will be
overwritten.
* Make sure that the communication cables are inserted properly so that they do not
come unattached.
* The number of files that can be selected at one time for sending is 10.
Selecting data to send:
• The data to be sent by the LINK menu (sender) can be specified individually.
• Press
ÏqD1
to display SEND menu
[A SELECT] ............. Sends files individually as de-
scribed below.
[01 ALL] .............. Selects and displays all files.
[02 List] ............... Selects and displays all list files.
[03 Matrix] ........... Selects and displays all matrix
files.
[04 Graph Eqn] ... Selects and displays all graph
equations.
[05 Solver Eqn] ... Selects and displays all solver
equations.
[06 Program] ....... Selects and displays all program
files.
[07 G_Data] ........ Selects and displays all graph data files.
[08 L_Data] ......... Selects and displays all list data files.
[09 Picture] ......... Selects and displays all picture data files.
[10 Slide] ............. Selects and displays all self-made slide shows.
[11 A ~ Z, θ] .......... Selects and displays all fixed memory of A to Z, and θ.
[B BACKUP] ............ Menu to send all data of files. Use this feature to send the entire
content.
<Example>
The operation procedure to send list “L1” and matrices
“mat A, mat B”, as well as graph equation “Y2”, is
explained below.
1. After selecting [1 SEND] in the LINK menu,
press
0
1
.
>
Å
≥
→
EL-9650-(13)En (259-264) 8/1/00, 9:33 AM262
To Next Page
Loading...
