Sharp er-3100 - Page 30

(4) Programmingfor protocol, etc.
This programmingis intended to select “ProcedureYes” or
“ProcedureNo” for protocol, “Modem connectionyest~or
“Modem connectionNo” for modem, and
“sensing yes” or
“SensingNo”
for control signals (DR and CS).
If “Procedure
No” is selected for protocol,
sending of print data alone
can be accomplishedas a transmissionjob.
In this case
this job is performed even if
“Sending of print data
Disable” has been selected in (1) “Programmingto select
data handling functions.”
a. Programmingprocedure
Perform this programmingin the PGM mode by using the
followingprocedure.
When A, B, C, and
D are all zeroes
293
n
~’
● ~
~
EABCD~
z
T
A, B, C, and D are all
set to zeroes when master
resetting is taken.
Table 7
I
2
Modem connectionYes, procedureYes
I
A 1 Modem connectionNo, procedure
NO
o
Modem connectionNo, procedureYes
B 1/0
I
Sensing of DR signal No/Yes
I
c 1/0
Sensing of CS signal No/Yes
ER off time in the slave in the case
of modem connectionYes:
Whenn=O,
D n
the ER off time is approx. 3 sec.;
(o-9) and when n =
1 thru 9, that time is
approxe (n x 10) sec.
This selection
is valid only
when A is 1.
–26–