To accomplish the S10 test, perform the following key operation
in the SRV mode:
122
~m
Test results are printed on the receipt and journal at the cash
register.
I
122
I
Normalprintout
I
EX––––
122
I
Errorprintout
x:
El:
E2:
E3:
1
to 3
ER-DRerror
Transfererror(dataerror)
Time-outerror
If an error printout occurs, check the S10 connector,including
the internal cable within the cash register, to see if it is in
position.
8.4 Programming
1. Modificationof the SRV-modeprogram
0 Programmingof the data rate (Prior to this programmingprint out
the current SRV-modeprogram by job number 900.)
Data entry with
numeric keys
In the above key operation,
A, B, C, and D each refer to preset
data of job number 909; and for convenience,data in the fourth
column is called A, the one in the third COlumn B, the one in the
second column C, and the one in the first column D.
Of these data,
data C serves to decide the data rate.
Select a
desired data rate according to Table 17.
–45–
To Next Page
Loading...
