Sharp er-3100 - Presets Loader Operational Check

0 Installationof the ER-52CB S10 interface cable and ER-OIFD
3.5-inch floppy disk unit (for data transfer between the ER-31OO
and the ER-OIFD)
1.
Refer to the ER-OIFD InstallationManual.
2. Connect the ER-52CB to the S10 connectoron the left side of
the ER-31OO and to the serial interfaceconnector (@) of
the ER-OIFD (see Fig. 13).
3.
Open the cover on the right side
its programming.
(Refer to 8.6
of the ER-OIFD and perform
“Use of the ER-OIFD”.)
Frontview
Backview
POWERLED
ON whentheERO1.FDpoweris on.
ERRORLED
ON whentheFD read/writeerror
is met.
Also,usedto indicate
diskinitialization.
ERRORLED
On at a datatransfererror.
Also,usedto indicatedisk
initialization.
RUNkey
Usedto startdatatransfer
betweentheEROIFDandtheECR.
3.5”FD
Serialinterfaceconnector
(~L level)
Serialinterfaceconnector
(RS232Clevel)
POWERswitch
AC adapterjack
AC adapter
b
Fig. 13
8.3 Operationalcheck
Perform the S10 test in the SRV mode.
Testing of the ER-52cB requires the ER-52cB, loop back connector
(UKOG-6651RCZZ), and service key;
and testing of the ER-67Lc
requires the ER-67LC, ER-52cB, loop back connector
(UKOG-6639RCZZ), and service key.
–44–