Sharp er-3100 - Data Sending and Receiving

Table 17
Data rate
Data C
9600 BPS
o
4800 BPS 1
2400 BPS
2
1200 BPS
3
600 BPS 4
Note:
For data C never enter any digit other than those shown in
Table 17.
Data A, B, and D do not need to be changed. Enter the
same data as data A, B, and D of job number 909 shown in
the SRV-mode program list printed by job number 900 before
installingthe option.
If data A is O, enter data B, C, and D in this sequence
without entering this zero.
8.5 Data sending and receiving
Data transmissioncan be started after the receiver has been set
up.
1.
Receive mode entry
Turn the mode switch to the SRV position and perform the
followingkey operation:
998~
a
~’~
—
‘~w
This operationreadies the ER-31OO for receiving S10 data.
When the ER-31OO enters the receive mode, the mating device,
which may be an ER-3100 cash register,ER-OIFD floppy disk unit,
or personal computer, can start S10 data transfer.
2.
Send mode entry
Turn the mode switch to the SRV position and perform the
followingkey operation:
996
a
~,
●
~~~
m
T
This operation starts the transferof S10 data stored in every
RAM in the ER-31OO.
–46–