Sharp ER-A450T - Character Assignment Method; Date, Time Programming; Tax Table Programming; Programming Key Layout

15) DATE, TIME PROGRAMMING.
Mode : PGM2
DATE: date entry format follows SRV JOB#912-A settings (6 digits)
TIME: 24 hour system (4 digits)
MRS = DATA: 01/01/00
TIME: 00:00
16) TAX TABLE PROGRAMMING
72 BREAKPOINTS CAN BE PROGRAMMED FOR EACH TAX-
TABLE.
(If the interval between break points is 1 dollar or more and less than 100
dollar, a maximum of 36 breakpoints is programmed for each table.)
DEPRESSION OF THE SBTL KEY AT THE FOLLOWING POINTS
WILL RESULT IN A TAX TABLE DELETE OPERATION.
A: INTERVAL BETWEEN BREAKPOINTS
1 DOLLAR OR MORE AND LESS THAN 100 DOLLAR = 1
BELOW 1 DOLLAR = 0
B: TAX TABLE No.
TABLE 4/TABLE 3/TABLE 2/TABLE 1 = 4/3/2/1
TAX RATE : 0.0000 - 99.9999
CYCLE : 0 - 9999
INITIAL TAX : 0 - 999
LOWER TAX LIMIT : 0 - 99999
BREAK POINT : 0 - 99999
MRS = NO TAX
4. Character assignment method
∼ Using the alphabet assignment method ∼
Programming key layout
Using the ten key of the ECR
Note: The
00 key is used to enter each 3 digit alpha code.
Examples
“ A
(Shift-2)
“ A =“ is set
(DC)
“ A = A (double character code) is set
(Shift)
“ A = a (lowercase letter) is set
Once the
(Shift)
key is pressed, it stays down until it is pressed
again.
XXXXXX
HHMM
DATA
TIME
#
XXXXXX
@/FOR
AB
@/FOR
Declaration of TAX
TAX rate
XXX @/FOR XXXX
@/FOR
Initial TAX Cycle
XXXXX @/FOR XXXXX @/FOR
Break point Lower TAX limit
CA/AT
TAX
@/FOF
SBTL
Push alphabet
Repeat
:
+
ZWRMHC
YVQLGB
XUPKFA
SNID
TOJE
?
(BS)
(DC)
(Space)
1
23
4
56
7
89
O
<
>
;
-
#
@
=
?
)
%
$
/
.
&
!
BACK
Space
( )
<
( )
<
( )
( ) ( )( )
( )
( )
-
§
æ
Æ
£
Pt
(Shift-2) (Shift)
øç
Φ
( ) : Function key
(DC) : Double character code entry key (One-shot)
(Shift) : Character shift key (Stay-down)
(Shift-2) : Mark key (One-shot)
(BS) : Back space key
@/FOR 00XXX
3 digits
SBTL
Repeat