CHAPTER 3. OP X/Z, X1/Z1,X2/Z2 MODE
The following categories of reports can be printed by the ECR.
OP X/Z reports: These reports are taken by operators in order to
report their own sales data.
XI/Z1 reports: These reports are taken by the supervisor or man-
ager in order to check and report daily sales totals
at that point.
X2/Z2 reports: These reports are taken by the owner or manager
in order to check and report periodic (weekly or
monthly) totals.
MGR/Flash-read: These reports are taken by the owner or manager
in order to check and display daily sales totals at
that point.
To print reports, use the following key entry sequence
MODE *1
OP X/Z X1/Z1 X2/Z2 JOB# or KEY DATA FOR READING
REPORT NAME X Z X1 Z1 X2 Z2 *3 NOTE
GENERAL
00 ---
UPC (All)
09 ---
(Pick up)
09 PICK UP *4
UPC BY DEPT.
01 DEPT CODE
UPC ZERO SALES (All)
07 ---
(By DEPT.)
07 DEPT CODE
DEPT./GROUP
10 ---
IND. GROUP
12 GROUP No.
GROUP TOTAL
13 ---
PLU BY RANGE
20 PLU CODE *2
PLU BY DEPT.
21 DEPT CODE
PLU ZERO SALES (All)
27 ---
(By DEPT.)
27 DEPT CODE
PLU PRICE CATEGORY
29 PRICE *2
TRANSACTION
30 ---
CID
31 ---
ALL CASHIER
50 ---
IND. CASHIER
51 ---
HOURLY (All)
60 ---
(Range)
60 TIME *2
DAILY NET
70 ---
PBLU
80 PBLU CODE *2
PBLU BY CASHIER
81
STACKED REPORT
90 ---
DEPT. SALES (Frash-read)
DEPTn --- *5
CID (Frash-read)
[@/FOR] --- *5
DAILY MET SALES (Frash-read)
[SBTL] --- *5
NON-ACCESSED UPC
105 ---
DELETE OF NON-ACCESSED UPC
105(*) ---
105(*) PICK UP *4
(*) At this operation, the non-accessed UPCs data are printed and
deleted.
To stop the printing reports:
The printing of all reports can be stopped by the following operation.
Set the mode switch to "MGR" to cancel.
Note) When the printing is stopped, the consecutive number or Z
counter doesn’t return to the original value.
For Z reports, Memory is not reset when canceled.
*1 X1: Daily X report
X2: Periodic X report
Z1: Daily Z report
Z2: Periodic Z report
*2 The time interval range and PLU code range can be specified by
entering the start and end numbers according to the following
procedure. When specifying a single time interval or PLU code,
the start number has only to be entered.
*3 When 2 is entered in the third digit of a job code, periodic reports
are printed.
Example: Daily general report; job code 100
Periodic general report; job code 200
JOB#
@/FOR
CA/AT
Reading
Resetting
Range is required
All
Start No. End No.
@/FOR
XXXXXX XXXXXX
To Next Page
Loading...
