Sharp HT-X1H - Powering On the System; Connecting the AC Power Lead; Turning the System On

04/10/16 HT-X1H(H)E2.fm
E-20
ENGLISH
TINSZA030SJZZ
HT-X1H
8
Preparation for Use
! Connecting the AC power lead
After checking all the connections have been made correctly, plug
the AC power lead to the AC power input socket of the subwoofer/
amplifier unit, and then to the wall socket.
Notes:
"
Never use a power lead other than the one supplied. Otherwise,
a malfunction or an accident may occur.
"
Unplug the AC power lead from the wall socket if the subwoofer/
amplifier unit will not be in use for a prolonged period of time.
! To turn the power on
Press the ON/STAND-BY button.
If the power does not turn on, check if the AC power lead and sys-
tem connection cable are plugged in properly.
To set the system to stand- by mode:
Press the ON/STAND-BY button again.
Note:
After the system enters the power stand- by mode, wait a few sec-
onds to turn on again.
Cooling fan:
A cooling fan is built into this subwoofer/amplifier unit for better heat
radiation. Do not cover the opening in this section with any obsta-
cles to avoid damage to the subwoofer/amplifier unit.
Wall socket
(AC 230 V, 50 Hz)
Subwoofer/
amplifier unit
Cooling fan
Subwoofer/
amplifier unit
Main unit