Sharp LC-40LE730E - Appendix - Reference Information; Abbreviation List; Software License Information

41
LC-40LE730
LC-46LE730
 Supports self- or bus-powered operation.
 USB251xB2 and USB251xBi products support the USB Battery Charging specification.
 Package: 36-pin QFN (6x6 mm).
• IC9553: Low Dropout LDO (USB2)
Part number: S-1170B50UC-OUJTFG
Sharp code: VHIS170B50U-1Y
http://datasheet.sii-ic.com/en/voltage_regulator/S1170_E.pdf
The S-1170 Series is a positive voltage regulator with a low dropout voltage (LDO), high output voltage accuracy, and low current
consumption developed based on CMOS technology.
A built-in low on-resistance transistor provides a low dropout voltage and large output current, a built-in overcurrent protector
prevents the load current from exceeding the current capacitance of the output transistor, and a built-in thermal shutdown circuit
prevents damage caused by the heat. An ON/OFF circuit ensures a long battery life. Compared with the voltage regulators using the
conventional CMOS process, a larger variety of capacitors are available, including small ceramic capacitors. Small SOT-89-5 and
6-Pin HSON(A) packages realize high-density mounting.
Features
 Output voltage: 1.5 V to 5.5 V, selectable in 0.1 V steps.
 High-accuracy output voltage: ±1.0%.
 Low dropout voltage (LDO): 120 mV typ. (3.0 V output product, Iout =300 mA).
 Low current consumption: During operation 80 µA typ. 160 µA max., During shutdown 0.1 µA typ. 1.0 µA max.
 High peak current capability: 800 mA output is possible (@ Vin >Vout(S) +1.0 V) *1
 Built-in ON/OFF circuit: Ensures long battery life.
 Low ESR capacitor can be used: A ceramic capacitor of 4.7 µF or more can be used for the output capacitor.
 High ripple rejection: 70 dB typ. (@ 1.0 kHz)
 Built-in overcurrent protector: Overcurrent of output
transistor can be restricted.
 Built-in thermal shutdown circuit: Damage caused by
heat can be prevented.
 Package: SOT-89-5, 6-pin HSON(A).
• IC9553: 2Mbit SPI-FLASH Memory
Part number: W25X20BV
Sharp code: RH-IXD084WJZZY
http://www.winbond.com/NR/rdonlyres/AEC6E481-6616-4555-B339-6E79D17810AC/0/W25X10BV_W25X20BV_W25X40BV.pdf
 Single and Dual Serial Peripheral Interface.
 Uniform 4KB erasable sectors & 32KB/64KB erasable blocks.
 1024 pages (256 bytes), page program in 0.7mS (typ.)
 Fast Read (0Bh), Fast Read Dual Output (3Bh) and Fast Read Dual I/O (BBh) instructions.
 Clock operation up to 104MHz (208MHz equivalent with Fast Read Dual Output).
 2.7 to 3.6V power supply.
 4mA active read current, 1µA power down current.
 -40° to +85°C operating range.
 Electronic ID in Single or Dual I/O mode.
 Read Unique ID (4Bh) instruction.
 Hardware and software write protection for top or bottom blocks.