Sharp LC-40SH340K Service Manual

69
LC-40SH340E
LC-40SH340K
1. Please copy the files to USB (root).
 mb60_en.bin
 mboot.bin
 usb_auto_update.txt
2. Turn power to OFF by mechanical switch(rocker switch) or removing AC
plug. And plug the USB to TV
3. Keep pressing OK key from remote controller and then turn the TV power
to ON(by mechanical switch or by inserting the AC plug) and keep OK key
pressed until the stanby led blinks rapidly(rapid blinking is faster than
normal blinking)
4. When the led is started to blink rapidly, you can release the OK key.Please
wait approximately for 1-2 minutes.
5. When the blinks of led is stopped, TV opens autamatically with the new
SW.
Analog - Digital SW update via USB
SOFTWARE UPDATE
#>?

Sharp LC-40SH340K Specifications

General

Teletext function	Yes
DVI port	No
HDMI version	1.3
SCART ports quantity	1
Product color	Black
Mercury content	60 mg
Panel mounting interface	400 x 400 mm
Display diagonal	40 \
Display technology	LCD
Display diagonal (metric)	102 cm
Annual energy consumption	177 kWh
Audio decoders	Dolby Digital, Dolby Virtual Speaker
RMS rated power	12 W
Power consumption (standby)	0.5 W
Analog signal format system	NTSC, PAL, SECAM
Digital signal format system	DVB-T

Weight and Dimensions

Depth (with stand)	323 mm
Width (with stand)	970 mm
Height (with stand)	657 mm
Weight (with stand)	18300 g
Depth (without stand)	91 mm
Height (without stand)	613 mm