Sharp LCD MONITOR - Menu Operations; Network Configuration and System Reset

Operation
39

TCP/IP setting
(TCP/IP)
Set the TCP/IP manually.
1
Select “Off” for “DHCP Client”, then press
ENTER.
2
Select “TCP/IP”, then press ENTER.
3
Enter “IP Address” using
▲
/
▼
/
◄
/
►
, then press
ENTER.
IP Address
Subnet Mask
Gateway
192.168.150.002
255.255.255.000
000.000.000.000
MENU [Setup---TCP/IP]
4
Enter “Subnet Mask” using
▲
/
▼
/
◄
/
►
, then
press ENTER.
5
Enter “Gateway” using
▲
/
▼
/
◄
/
►
, then press
ENTER.
Selectable
items
Description
IP Address Factory default setting:
192.168.150.002
Enter an IP address appropriate for
the network.
Subnet
Mask
Factory default setting:
255.255.255.000
Set the subnet mask to the same as
that of the computer and equipment
on the network.
Gateway Factory default setting:
000.000.000.000
* When not in use, set to
“000.000.000.000”.
• Confi rm the existing network’s segment (IP address
group) to avoid setting an IP address that duplicates the
IP addresses of other network equipment or computers.
If “192.168.150.002” is not used in a network with an IP
address of “192.168.150.XXX”, you don’t have to change
the monitor IP address.
• For details about each setting, consult your network
administrator.
Note

Confi rming the monitor information
(Status)
You can confi rm the following information.
• DHCP Client
• IP Address
• Subnet Mask
• Gateway
• MAC Address
• Monitor Name
• Serial Number
• For information on how to change the monitor name, see
“SETUP MANUAL” contained in the supplied CD-ROM.
Note

Returning to the default settings
(All Reset)
This function allows you to initialize the settings you
have made in the monitor.
1
Press
▲
/
▼
to select “All Reset” and press
ENTER.
2
Press
▲
/
▼
to select “Yes” and press ENTER.
Menu operations