Sharp MX-2010U

SHARP
TECHNICAL BULLETIN INDEX
59
Note: Excludes Part Change/Correction Information.
Reference
Description
Model
COP2251
Countermeasures to prevent noise from Right lower door unit, MF paper
feed unit and Right door unit.
All
COP2248
Countermeasures against paper misalignment and paper jam when
discharging paper to the centre tray.
All
COP2244
Measures to prevent noise from the Fusing drive unit.
All
COP2230
Strength enhancement to prevent cracking of socket for Hinge R on the
upper cabinet rear.
All
COP2228
EEPROM handling
All
COP2222
Rom version upgrade (including revision history)
MXFN17
COP2217
Countermeasures against power failure caused by defective L207 inductor
on the DC power supply PWB
All
COP2214
Measures to prevent C1-10 or C1-14 trouble caused by MC PWB.
All
COP2206
Removal of LSU shutter
All
COP2205
Adjustment to improve creasing of paper when operating under high
humidity environment.
MX-2010U
COP2200
Measures to prevent paper full detection error after removing paper
jammed in the delivery unit.
All
COP2199
Measures to prevent the noise from RSPF transport sections.
MX-2310U
COP2190
Printer installation under Mac OSX 10.10
All
COP2189
Specification change to support the new wireless standard in Australia
MX-EB13
COP2185
Countermeasure for creasing of paper when feeding A4R from the paper
feed cassette
All
COP2184
Improvement of conductivity level between Fusing upper stay and Fusing
rear discharge brush.
All
COP2175
Measures to prevent E7-11 trouble caused by faulty LED driver PWB.
All
COP2170
Elimination of one way gear and Gear 19T/31T within the fusing unit.
All
COP2169
Measures to prevent C4-00 error code.
All
COP2162
Measures to prevent noise and/or POD1_N paper jam caused by the worn
fusing drive gear.
All
COP2159
Measures against noise from PS clutch within RSPF unit.
All
COP2155
Caution when replacing MC PWB to overcome the C1-14 trouble
All
COP2150
Measures against toner smudge on the paper
All
COP2145
Enhancement of the 2nd transfer belt frame to prevent pawl breakage
All
COP2143
Removal of a fixing screw on DV side plate
All
COP2133
Measures to prevent noise from the fusing drive unit.
All
COP2118
Countermeasures to prevent blank image caused by the DV belt B at the
rear side of the DV unit.
All
COP2112
Measures to prevent noise caused by the transport follower roller
All
COP2109
Improvement to prevent noise from the paper feed reverse roller within the
paper feed unit.
All
COP2107
Measures against PDPPD1_N paper jam caused by the deteriorated cushion.
MX-FN17
COP2103
Enhancement of MF rotation pawl spring
All