Countermeasures to prevent improper operation of the coin vendor device
with parallel connection.
Sharp Remote Device Manager [SRDM] v1.4
Measures against H3-00 error code caused by the electrostatic discharge.
Countermeasures against L4-06 error code.
Further improvement to prevent 2nd transfer belt meandering.
Modification of Control PWB
Firmware version upgrade and change of transport motor
Registry growth when using an auto created printer under a citrix or
terminal services environment.
Countermeasures against noise caused by the vibration of heavily
contaminated cleaning web roller.
Caution when replacing the fusing pressure spring.
Countermeasures against toner dispersion from the DV unit when printing
in high coverage and high volume.
Countermeasures against noise from the transport follow roller in the RSPF
base tray.
Countermeasures against noise from the reading rear roller within the RSPF
transport section.
Improvement to strengthen the hinge mount section on the SPF base tray.
Countermeasures to prevent noise from the main drive unit.
Improvement for gap variation between the fusing separate plate and
fusing belt.
Countermeasures against transfer cleaning blade flip
Elimination of the remain detect cover
Enhancement to prevent the POD2 actuator of the delivery lower PG
coming off.
Sharp Remote Device Manager [SRDM] v1.3
Improvement against noise from the RSPF/DSPF transport section
Improvement for engagement between the main drive unit & process unit
Improvement against noise from the paper feed drive unit section
Improvement for contamination (lines) on the rear edge of paper
Tentative measures against contact problem of 7 inch LCD connector
Enhancement to prevent paper jam caused by unhooked bunch roller
pressure lever
Firmware update for installation of MXFN10 & MXFN17 [revised February
2013]
Changes in Sim43-1 and Sim55-1 SW18-1 to improve first copy out time
Measures to reduce the noise from RSPF unit, main drive unit and etc.
Countermeasure to prevent paper jam due to undetected paper passing the
PPD2 sensor
Further improvement to prevent the fusing belt from meandering
Poor fusing when copying/printing after recovering from pre heat mode
To Next Page
Loading...
