Reduction of noise from actuator movement on the RSPF transport or base
tray sections.
Elimination of Fusing Lower PG Pawls on Fusing Rear Upper PG
No power due to broken electronic circuit on DC power supply PWB
Elimination of the right adjuster
F2-64/65/66/67 Trouble code
Defective contact with SD card terminal
Service manual correction - Troubleshooting [Jam Code]
Improved cleaning performance of the process unit cleaning blade
Measures against the peeling of the fusing paper enter PG mylar
Measures to prevent fusing harness damage
Enhancement to prevent condensation inside the scanner unit
Scan to OSX10.7 using FTP
Enhancement to prevent fusing belt damage
Service manual correction - Maintenance [Fuser]
C4-00 trouble due to misalignment of the TC PWB
Pressure release idle gear strength increase
Configuring ID card with internal user control
Measures to prevent the follower roller end within the 1st transfer unit
becoming damaged
Rom version upgrade (including revision history)
Measures to prevent the 2nd transfer belt damage
Measures to reduce the sound level of the actuator movement when
scanning originals through document feeder
Improvement of silence level inside the paper feed unit and the transport
drive unit.
Measures to prevent the DV drive pulley in the main drive unit becoming
damaged
Abnormal noise from the right door unit
Change of DV cover to prevent toner splatter
Breakage of the heater lamp upper harness coating
Fusing pressure spring strength increase
Measures to prevent fusing belt damage due to belt slippage.
Further improvement against the deformation of the handle securing plate
Sharp Remote Device Manager (SRDM) v1.1
Addition of arm holder to the original tray cover [RSPF]
Abnormal noise created by the transfer contact spring of the high voltage
power supply coming loose
Countermeasure against the deformation of the main body position boss
POD2_N jam within the delivery unit
Measures against toner dispersion from the process unit
To Next Page
Loading...
