Measures against deformation of the handle securing plate
Preventing the rear side of the fusing lock lever mount of the fusing unit
from breaking
Abnormal noise from the waste toner driving section
Application of screw lock paint on drive units
Addition of fusing harness protect mylar
Fusing belt end damage caused by fusing belt slipping
Countermeasure against transfer mode detector contamination (L4-06
trouble) within the main frame rear side.
Abnormal noise from the BK drive frame on the main drive unit
Precaution when connecting the fusing interface harness lines
Setting of service part for MG Roller rotation in the DV unit
Precaution when mounting the rear cabin upper
Abnormal noise due to tooth misalignment between the main driving unit
and process unit.
Original stacking improvement when using the RSPF
Precaution when executing auto developer adjustment setting (Sim25-02)
Sharp Remote Device Manager (SRDM)
To Next Page
Loading...
