Upgrade of PAU5 (Version 5.3.0)
Measures to prevent the LSU shutter spring (A) becoming caught
Improvement against double feeding from the desk units
Caution when transporting or moving machine(s)
Abolishment of LCD Mylar A/B within the Operation LCD Panel
Rom version upgrade (including revision history
Double feed from the paper feeding unit
Measures against incorrect detection of the last sheet during feeding
(bypass).
Countermeasures against Transfer CL Blade Flip (L4-12 trouble)
Change of initial values for pre-heat & auto power shut-off modes in
support of Energy Star v1.1 (Tier II)
Improvement of inner finisher - FPP1_N jams
Operation procedure of PAU5 for service personnel
Paper feed improvement of the RSPF
Measures against MFT paper jams, due to the MF flapper solenoid.
Installation Manual correction - Data Security Kit (DSK)
Dirty marks on the edge of the paper
Measures against creasing or poor fusing when feeding envelopes
FPPD1_S or POD2_S jams within the inner finisher
FPRD_S jam (Finisher compiler remaining jam) only when using B5 paper
size
Measures to prevent the pressure release detection harness from being
caught by the fuser upper cover
L4-16 fusing pressure release trouble caused by scratched pressure release
detect actuator
Improvement of the fusing and delivery drive gear (38-9T) mounting
procedure
Caution when cleaning the operation panel
Caution when applying starting powder after replacing the OPC Drum or
Transfer Belt [revised October 08].
To Next Page
Loading...
Need help?
General
