MX-FN27, MX-PN14 OPERATIONAL DESCRIPTION 6 – 6
B. Stacking Operation
The paper delivered from the delivery roller is stacked on the processing tray and aligned in the feed direction.
How paper is delivered from the delivery roller and stacked on the processing tray is described below.
1) After the Delivery sensor (FNPS1) detects the trailing edge of the paper, the Paddle motor (FNM10) runs to move the paddle unit down. The pad-
dle driven by the Feed motor (FNM1) delivers the paper toward the processing tray. After a given time elapses, the paddle unit is moved up.
2) After the Delivery sensor (FNPS1) detects the trailing edge of the paper, the Return belt motor (FNM2) runs to move the return belt unit down.
The delivered paper is pressed against the stopper by the return belt driven by the Feed motor (FNM1) and aligned in the feed direction. After a
given time elapses, the return belt unit is moved up.
NOTE: Paper is not fed by the returned belt if the paper width is more than 297.0 mm or less than 120 mm or if the paper is special paper or enve-
lopes.
FNPS1
FNM1
Paddle
FNM10
Processing Tray Unit
Return Belt
FNPS1
FNM2
FNM1
Stopper
To Next Page
Loading...
