Sharp MX-M350 - Page 156

MX-M350/M450 N/U SIMULATION 9 - 17
Operation/Procedure
1) Select 1 (YES) with 10-key.
2) Press [START] key. (The trouble display is canceled.)
Operation/Procedure
1) Select 1 (YES) with 10-key.
2) Press [START] key. (The trouble display is canceled.)
Operation/Procedure
1) Select 1 (YES) with 10-key.
2) Press [START] key. (The trouble display is canceled.)
Operation/Procedure
1) Select 1 (YES) with 10-key.
2) Press [START] key. (The trouble display is canceled.)
13
13-0
Purpose Clear/Cancel (Trouble etc.)
Function
(Purpose)
Used to cancel the self-diag "U1" trouble. (Only
when FAX is installed.)
Section FAX
Item Trouble
1 YES After canceling U1 trouble, the machine returns to
the main code entry standby mode.
2 NO Without canceling U1 trouble, the machine
returns to the main code entry standby mode.
14
14-0
Purpose Clear/Cancel (Trouble etc.)
Function
(Purpose)
Used to cancel excluding the self-diag U1/LCC/
U2/PF troubles.
Item Trouble Error
1 YES After canceling the trouble other than U1, U2, PF,
and LCC, the machine returns to the main code
entry standby mode.
2 NO Without canceling the trouble, the machine returns
to the main code entry standby mode.
SIMULATION 13
U1 TROUBLE CANCELLATION.
ARE YOU SURE?
1. YES
2. NO
1
SIMULATION 14
TROUBLE CANCELLATION. (OTHERS)
ARE YOU SURE?
1. YES
2. NO
1
15
15-0
Purpose Clear/Cancel (Trouble etc.)
Function
(Purpose)
Used to cancel the self-diag "U6-01, 02, 03, F3-
12, 22" (large capacity paper feed tray, paper feed
trays 1, 2) troubles.
Section LCC
Item Trouble
1 YES After canceling the LCC trouble, the machine
returns to the main code entry standby mode.
2 NO Without canceling the trouble, the machine
returns to the main code entry standby mode.
16
16-0
Purpose Clear/Cancel (Trouble etc.)
Function
(Purpose)
Used to cancel the self-diag U2 troubles.
Section MFP control PWB, PCU PWB, scanner control
PWB
Item Trouble
1 YES After canceling the U2 trouble, the machine returns
to the main code entry standby mode.
2 NO Without canceling the trouble, the machine returns
to the main code entry standby mode.
SIMULATION 15
LCC TROUBLE CANCELLATION.
ARE YOU SURE?
1. YES
2. NO
1
SIMULATION 16
U2 TROUBLE CANCELLATION.
ARE YOU SURE?
1. YES
2. NO
1