MX-M503N AR-SU1 13 – 1
MX-M503N
Service Manual
[13] AR-SU1
1. Unpacking
A. Remove the stamp unit
B. Check the parts in the package
1) Check to confirm that all the parts are included in the package.
* When replacing the stamp cartridge, Refer to “Stamp cartridge
replacement” in the “User’s Guide” (PDF document). The user
must be notified of that. (Do not refer to “Stamp cartridge replace-
ment procedure” (package part No. 2).)
2. Installation
<Note before installation>
* Before execution of installation, check to confirm that the data
lamp on the installation panel does not light or flash.
A. Turn off the power of the main unit
1) Turn OFF the power switch on the operation panel.
2) Open the front cabinet, and turn OFF the power switch.
3) Disconnect the power plug from the power outlet.
B. Install the stamp unit
1) Open the DSPF/RSPF unit, and remove the OC mat.
For removing and fixing screws, use a stubby screwdriver.
* If stubby screwdriver is not available, loosen the screw of
the angle adjustment plate on the rear side of the machine,
and lower the angle adjustment plate and put the DSPF/
RSPF unit straight.
No. Part name Quantity
1Stamp unit 1
2 Stamp cartridge replacement procedure* 1
3 Stamp cartridge 3
4 Installing screw 1
To Next Page
Loading...
Need help?
General
