MX-M503N MX-DEX8/DEX9 2 – 1
MX-M503N
Service Manual
[2] MX-DEX8/DEX9
1. Unpacking
A. Removal of the desk unit
B. Removal of the fixing material and packing
parts
* If the connector is removed first, it may be pinched in the install-
ing procedures. Therefore, keep it packed when unpacking the
package, and unpack it when connecting the connector to the
machine.
1) Remove the fixing material and packing parts.
C. Check the packed items
1) Check that all the items are included in the package.
2. Installation
<Note before installation>
* Before starting installation, check to insure that the data lamp on
the operation panel does not light up or blink.
A. Turn off the power of the main unit
1) Turn OFF the power switch on the operation panel.
2) Open the front cabinet.
Turn OFF the power switch in the front cabinet of the main unit.
3) Disconnect the power plug of the main unit from the power out-
let.
No. Names of bundles Quantity
1 Right adjuster 1
2 Fixing screws (M4 x 8) 4
To Next Page
Loading...
Need help?
General
