Sharp Notevision PG-B10S User Manual

-30
Menu Items
The following shows the items that can be set in the projector.
Note
When using the INPUT 1 mode:
• In the “Picture” menu of INPUT 1, “Color”, “Tint” and “Sharp” are only displayed when “Signal Type” is set
to “Component” or set to “Auto” and the input signal is recognized as a component signal.
• In the “Picture” menu of INPUT 1, “sRGB” is only displayed when “Signal Type” is set to “RGB” or set to
“Auto” and the input signal is recognized as an RGB signal.
When using the INPUT 2 or INPUT 3 mode:
• There is no “Signal Type” item in the “Picture” menu.
• In the “Picture” menu of INPUT 2 or INPUT 3, “Sharp” is adjustable between –3 and +3.
+30−30
+30−30
+30−30
+30−30
+30−30
+30−30
+30−30
Main menu Sub menu
Contrast
Bright
Color
Tint
Sharp
Red
Blue
Reset
sRGB [ON/OFF]
CLR Temp
Gamma
Signal Type
Memory
Auto
RGB
Component
5500 K
6500 K
7500 K
8500 K
9300 K
10500 K
Standard
Presentation
Cinema
Game
Memory 1
Memory OFF
Memory 5
Picture
Page 36
Page 36
Page 36
Page 37
Page 37
Page 38
Page 38
+15−15
+30−30
+30−30
+30−30
Fine Sync
Clock
Phase
H-Pos
V-Pos
Reset
Special Modes
Auto Sync [ON/OFF]
Signal Info
Page 39
Page 39
Page 39
Page 40
Page 40
Note
When using the INPUT 1 mode:
• “Fine Sync” menu is only displayed when the projector input is INPUT 1.
“Picture” menu
“Fine Sync” menu

Sharp Notevision PG-B10S Specifications

General

Brand	Sharp
Model	Notevision PG-B10S
Category	Projector
Language	English