-41
Using the
Menu
You can use the “Options” menu to enhance the usage for the projector.
Lamp Timer (Life) (Check-
ing the Lamp Life Status)
You can confirm the cumulative lamp usage time
and the remaining lamp life (percentage).
Display the “Options” menu to check the
lamp life status.
Checking the menu screen Page 34
Example: “Options” menu screen for
INPUT 2 (S-Video) mode
Description of Lamp Life
Note
• It is recommended that the lamp be changed
when the remaining lamp life becomes 5%.
For lamp replacement, contact your nearest
Sharp Authorized Projector Dealer or Service
Center.
• The table above indicates rough estimates in the
case of using only in each mode shown. Remain-
ing lamp life changes within the range of the val-
ues shown depending on the frequency at which
“Eco Mode” is switched to “
” (Eco mode) and
“ ” (Standard mode) (see page 43).
Using the “Options” Menu
Lamp usage condition
Operated exclusively
in Eco mode ( )
Operated exclusively
in Standard mode ( )
Remaining lamp life
100% 5%
Approx. Approx.
4,000 hours 200 hours
Approx. Approx.
2,000 hours 100 hours
OSD Display (Setting On-
screen Display)
This function allows you to turn the on-screen
messages on or off.
Select “ ” (ON) or “ ” (OFF) in “OSD
Display” on the “Options” menu.
Setting the menu screen Page 34
Example: “Options” menu screen for
INPUT 2 (S-Video) mode
Description of “OSD Display” Settings
*
Displayed when the STANDBY button is pressed while
the keylock function is active.
Description
All On-screen Displays are displayed.
INPUT/VOLUME/AV MUTE/FREEZE/
AUTO SYNC/ENLARGE/ “An invalid
button has been pressed.” / “All buttons on
Projector are locked.”
*
are not displayed.
Selectable settings
(ON)
(OFF)
To Next Page
Loading...
Need help?
General