To Next Page

To Previous Page

-47

Using the

If you want to change the keycode, follow

the procedure below.

Note

• When “Anti-Theft” is selected, the password in-

put box will appear. After the password has been

entered, you can change the keycode.

1 Press the buttons on the remote

control or the projector to enter the

preset 4-digit keycode in “Old

Code”.

Press any button you like on the re-

mote control or the projector to en-

ter the new keycode.

3 Enter the same 4-digit keycode in

“Reconfirm”.

Note

• If you do not want to set a keycode, leave the

keycode field blank in steps 2 and 3 and press

If you want to clear the keycode input box,

follow the procedure below.

▼Keycode input box

Note

• When “Anti-Theft” is selected, the keycode in-

put box will appear.

• If no keycode is entered, the image will not be

displayed, even if the projector receives the in-

put signal.

1 Press on the remote control or

on the projector to turn on the

projector.

2 Enter the keycode you set when the

keycode input box is displayed.

Note

• When entering the keycode, press the buttons

previously set on the projector or the remote

control.

Sharp Notevision PG-B10S User Manual

Other manuals for Sharp Notevision PG-B10S