PN-K321/K322B SERVICE MENU/VARIOUS SETTING TOOL OPERATING PROCEDURES 4 - 31
WHEN “CANNOT OPEN INTERFACE. CANNOT CONNECT.
PLEASE CONFIRM SETTING” IS DISPLAYED:
・ Check to confirm that the COM port which is set by another tool
is not used. If the COM port is used by another tool, turn OFF
the tool.
WHEN “THIS MONITOR IS NOT SUPPORT. IS XXXX
PROCESSING CONTINUED?” IS DISPLAYED:
・ The display which is connected is not supported by this tool.
Use a tool which supports the displayed connected.
To Next Page
Loading...
