0-3
Section Content page
5.12 Automatic Feed …………………………………………………………….
5-22
5.12.1
（For TPR-1230, TPR-1230H）
…………………………………………
5-22
5.12.2
（For TPR-1600H, TPR-2000H）
……………………………………..
5-24
5.13 The spindle ………………………………………………………………...
5-25
5.14 Threading …………………………………………………………………..
5-25
5.15 The assembly and disassembly of the work table ……………………..
5-25
5.16 Cutting fluids for all kinds of material …………………………………
5-26
CHAPTER 6 Adjustment
6.1 General …………………………………………………………………….
6-1
6.2 The arm clamping lever …………………………………………………
6-1
6.2.1 (For TPR-1230, TPR-1230H) …………………………………………
6-1
6.2.2 (For TPR-1600H, TPR-2000H) …………………………………………
6-2
6.3 Adjust tighten the clamping device ……………………………………
6-3
6.3.1 (For TPR-1230, TPR-1230H) ……………………………………
6-3
6.3.2 (For TPR-1600H, TPR-2000H) ……………………………………….
6-3
6.4 Adjust tighten the clamping device ……………………………………
6-4
6.4.1 (For TPR-1230, TPR-1230H) ……………………………………
6-4
6.4.2 (For TPR-1600H, TPR-2000H) …………………………………………..
6-5
6.5 Adjustment for the backlash between the gearbox and the arm rail………...
6-6
6.6 Adjustment of the hydraulic pressure ……………………………….…
6-6
6.7 Adjustment of the clutch(for TPR-1600H,TPR-2000H)…………………….
6-7
CHAPTER 7 Maintenance
7.1 General …………………………………………………………………….
7-1
7.2 Daily Maintenance …………………………………………………………
7-1
7.2.1 Clearing …………………………………………………………………….
7-1
7.2.2 Please clean every parts using a metal brush and a rag, dipped with oil, to
rub them …………………………………………………………….………
7-1
7.2.3 The way to clean iron filings ……………………………………………
7-2
7.2.4 Lubrication ………………………………………………………………….
7-2
7.2.5 Change oil inside of the speed reduction of the arm elevating motor……….
7-3
7.2.6 Chang the oil inside the gearbox ………………………………………
7-4
7.2.7 Changing hydraulic oil in the hydraulic oil pump…………………………..
7-5
7.3 Replace the cutting fluids ………………………………………………
7-6
7.4 Maintenance and replacement period ………………………………….
7-6
7.5 Waste disposition …………………………………………………………...
7-6
To Next Page
Loading...