Sharp SF-2314

Note for assembly (1): When attaching the harness, be careful to
the connector color and the lead wire
color. (Carefully refer to the indication on
the PWB for connection of the harness.)
Example: YE (WH) → Yellow connector and white lead wire
YE = Yellow, WH = White, BK = Black,
GR = Green, BL = Blue
2. Manual paper feed section
2-1. Manual paper feed roller, manual takeup roller
1 Remove the manual paper feed unit from the copier.
2 Remove the roller auxiliary spring, the manual solenoid connector,
the E-rings in the front and the rear frames, and the bearing.
Remove the manual roller ass’y together with the solenoid holder.
3 Remove the manual feed takeup roller from the manual arm.
4 Remove the manual arm and the E-ring, and remove the manual
paper feed roller.
Note: Gear 20T has a positioning pin. When removing the
manual arm, be careful not to miss the positioning pin.
Note for assembly (1): The manual paper feed roller is provided
with the one-way clutch. When attaching
it, attach so that the arrow mark on the
roller is in the E-ring side. (Be careful to
the installing direction.)
2-2. Reverse rotation roller ass’y
1 Remove the manual feed roller ass’y.
2 Remove the reverse roller ass’y from the roller holder.
Gear 20T (Positioning pin included)
Arrow mark
6 – 5