Sharp SX 1075

SX™
Service and Maintenance Manual 3-142 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
SEALER ASSEMBLY
JAW POSITION SENSORS (con’t)
3. Position the setup jig against the back of left
guide rail so that the jig sits squarely against
the rear surface of the rail (surface 1 in Figure
3-361). Slide rear sensor bracket back until it
touches the jig (surface 2 in figure).
Be sure
the jig is only against the mounting bracket,
not the sensor itself. When in position,
tighten the mounting screw identified in Figure
3-361.
4. Move jig into position shown in Figure 3-363,
ensuring that it squarely touches the front
surface of the rear sensor (surface 3 in figure).
Slide front sensor back until it touches the front
surface of the jig (surface 4 in figure). Again,
ensure that the jig is touching only the
mounting bracket, not the sensor. Once in
position, tighten the mounting screw.
Left
Guide
Rail
Surface 1
“Home” Sensor Mounting Bracket
Setup
Jig
Surface 2
Figure 3-361. Setting the “Home” Jaw Position Sensor
Front of
Machine
“Home” Sensor
Mounting Bracket
Surface 4
Surface 3
“Near Home” Sensor
Mounting Bracket
Figure 3-363. Setting the “Near Home” Sensor
Figure 3-362. “Home” Sensor Mounting Screw
“Home” Sensor Mounting Screw
Figure 3-364. “Near Home” Sensor Mounting Screw
“Near Home” Sensor Mounting Screw