157
Procedure
Touch a pertinent key.
Take STEP 1 thru STEP 3 shown
above to open the window for
programming each direct key.
▼
▼
■ Direct PLU/dept. key
You can assign PLUs and departments directly to the keyboard. In the case of PLUs, you may assign up to
10-levels to be accessed directly on the keyboard.
In the case of setting “000001 DIRECT PLU”
• TYPE (Use the selective entry)
PLU: Assigns the key as a direct PLU key.
DEPT: Assigns the key as a direct department key.
NOTE
•
When selecting a department, the screen on which a
department code is to be entered (the message “DEPT.
CODE”) will appear.
•
When selecting a PLU, the screen on which a PLU code is to
be entered (“PLU CODE”) will appear.
• LEVEL1 thru 10 (Use the numeric entry)
Enter a PLU code for each level. For example, if you want to
use this key as PLU code1 (level 1) and PLU code101 (level
2), enter 1 for the “LEVEL1” and 101 for the “LEVEL2.”
NOTE
•
You cannot assign a PLU or a department to the position to
which a function key has been assigned.
▼
To Next Page
Loading...
