Sharp UP-3300

194
■ Zero skip
You can program whether or not to skip “0” in each report.
Program each item as follows:
• CLERK (Use the selective entry)
SKIP: Skips those data that are “0” in the clerk report.
NOT SKIP: Does not skip those data that are “0” in the
clerk report.
• TRANSACTION (Use the selective entry)
SKIP: Skips those data that are “0” in the transaction
report.
NOT SKIP: Does not skip those data that are “0” in the
transaction report.
• DEPARTMENT (Use the selective entry)
SKIP: Skips those data that are “0” in the department
report.
NOT SKIP: Does not skip those data that are “0” in the
department report.
• PLU (Use the selective entry)
SKIP: Skips those data that are “0” in the PLU report.
NOT SKIP: Does not skip those data that are “0” in the
PLU report.
• HOURLY (Use the selective entry)
SKIP: Skips those data that are “0” in the hourly
report.
NOT SKIP: Does not skip those data that are “0” in the
hourly report.
• DAILY NET (Use the selective entry)
SKIP: Skips those data that are “0” in the daily net
report.
NOT SKIP: Does not skip those data that are “0” in the
daily net report.
Procedure