Loading the Imaging Film
16
Loading the Imaging Film
Your fax uses a roll of imaging film to create printed text and images.
The print head in the fax applies heat to the imaging film to transfer
ink to the paper. Follow the steps below to load or replace the film..
Note: If there is paper in the paper tray, pull the paper release plate for-
ward and remove the paper before loading the imaging film.
When replacing the film, use a
roll of Sharp UX-3CR imaging
film. One roll can print about
100 letter-size pages.
The initial starter roll of
imaging film included with
your fax can print about
30 letter-size pages.
1
Open the operation panel by grasping
the finger hold and pulling up.
2
Pull the green release on the right side
of the machine forward, and open the
print compartment cover.
all.book Page 16 Wednesday, April 26, 2000 7:08 PM
To Next Page
Loading...
Need help?
General
