Setting the Date and Time
29
1. Installation
Setting the Date and Time
1
Press these keys:
The display will show:
Set the date and time by pressing the keys on the operation panel as
shown below.
ENTRY MODE
The date and time
appear in the display and
are printed at the top of
every page you fax.
3 key
*
key
FUNCTION key
STOP key
START/MEMORY
key
3
FUNCTION
2
1
3
9
4
5 6
7
8
0
Note: The imaging film and printing paper must be loaded before the date
and time can be set.
Do not set the date and time if you are using OpenLCR!
OpenLCR automatically sets the date and time each time your fax calls
OpenLCR and receives rate data. To ensure accurate use of the rate data, do
not change the date and time setting yourself. OpenLCR also sets the date
and time for you if you perform the fax transmission test (see page 40).
all.book Page 29 Wednesday, April 26, 2000 7:08 PM
To Next Page
Loading...
Need help?
General
