ii
Inserting a Cassette
1 Attach the power source to the
camcorder, then slide the cassette
compartment door release and open the
cassette compartment door.
2 Insert a commercially available cassette
fully with the window facing outwards,
and with the erasure protect tab facing
upwards.
3 Press the W mark gently until the
cassette holder clicks into place.
4 Wait for the cassette holder to fully
retract. Close the compartment door by
pressing the centre until it clicks into
place.
S
AV
E
REC
Inserting a Card
1 Make sure that the Power switch is set
to OFF.
2 Slide the card slot cover release and
open the card slot cover in the direction
of the arrow.
3 Insert a card into the slot as shown
below, and push it in as far as it will go.
4 Close the card slot cover.
Note:
• You can use an SD Memory Card (commer-
cially available) and a MultiMediaCard (only
supplied with VL-NZ10) for storing still
images with this camcorder, not a
SmartMediaE card or Memory StickE media.
In this operation manual, “card” refers to the
SD Memory Card or the MultiMediaCard.
Cassette compartment
door release
W mark
Erasure protect tab
Card slot cover release
Clipped corner
Label
To Next Page
Loading...
