30
Screen No. Parameter (item)/screen Initial value Setting/selection Record
3-26 Step 7 SV value S_07 (¦ho) h
3-27 Step 7 time t_07 (¦ho) h²hh
3-28 Step 7 PID No. P_07 (¦ho) h
3-29 Step 8 SV value S_08 (¦hp) h
3-30 Step 8 time t_08 (¦hp) h²hh
3-31 Step 8 PID No. P_08 (¦hp) h
3-32 Step 9 SV value S_09 (¦hq) h
3-33 Step 9 time t_09 (¦hq) h²hh
3-34 Step 9 PID No. P_09 (¦hq) h
3-35 Step 10 SV value S_10 (¦ih) h
3-36 Step 10 time t_10 (¦ih) h²hh
3-37 Step 10 PID No. P_10 (¦ih) h
4-0 Initial screen EVdi (~) ~
4-1 Event 1 type E1_m (~i¦)
4-2 Event 1 hysteresis E1_d (~i¦) jh
4-3 Event 1 standby action E1_i (~i¦)
4-4 Event 1 output characteristics E1_A (~i¦|)
4-5 Event 1 delay time E1dL (~i)
4-6 Event 1 latching E1_L (~i¦)
4-7 Event 2 type E2-m (~j¦)
4-8 Event 2 hysteresis E2-d (~j¦) jh
4-9 Event 2 standby action E2-I (~j¦)
4-10 Event 2 output characteristics E2_A (~j¦|)
4-11 Event 2 delay time E2dL (~j)
4-12 Event 2 latching E2_L (~j¦)
4-13 DI mode Di ()
5-0 Initial screen init () ~
5-1 Keylock setting LocK ()
5-2 Proportional cycle time o_C (¦}) Y:kh, P:k
5-3 Output characteristics Act (|) |
5-4 Hysteresis mode dFMd () ~
5-5 SV limiter lower limit value SV_L (¦) h
5-6 SV limiter higher limit value SV_H (¦) ikoh
5-7 PV bias value PV_b (¦) h
5-8 PV ramp PV_S (¦) shhh
5-9 PV filter time PV_F (¦) h
5-10 Measuring range code rAnG (|) Multi: hm
5-11 Input temperature unit Unit ()
5-12 Input range lower limit in_L (¦) h
5-13 Input range higher limit in_H (¦) ikoh
5-14 Input scaling lower limit Sc_L (¦) h
5-15 Input scaling higher limit Sc_H (¦) ikoh
5-16
Input scaling decimal point
position
dP () h
5-17 Time unit t_Un (¦)
5-18
Transition to FIX upon PROG end
and setting
EFiX (~)
To Next Page
Loading...
Need help?
General
