Shimadzu LCMS-8045 User Manual (English)

To Next Page

To Previous Page

2 Installation Conditions

LCMS-8045/8050 Pre-Installation Requirements

LCMS-8050

47L (7m

) Cylinder

In case of setting CID gas flow rate to standard (270kPa)

Reference operating time: 7,000 (L) / 0.012(L/min) / 60 (min) / 24(h) = approx. 405(days)

In case of setting CID gas flow rate to maximum (450kPa)

Reference operating time: 7,000 (L) / 0.020 (L/min) / 60 (min) / 24(h) = approx. 243 (days)

10L (1.5m

) Cylinder

In case of setting CID gas flow rate to standard (270kPa)

Reference operating time: 1,500 (L) / 0.012 (L/min) / 60 (min) / 24(h) = approx. 87 (days)

In case of setting CID gas flow rate to maximum (450kPa)

Reference operating time: 1,500 (L) / 0.020 (L/min) / 60 (min) / 24(h) = approx. 52 (days)

Precautions When Using High Pressure Gas Cylinders

When using gas cylinders, please observe the High Pressure Gas Safety Law, or the applicable laws for high pressure gas

cylinders governing the installation site.

1. Place gas cylinders outdoors, in a well-ventilated location out of direct sunlight. Deliver the gas indoors via gas pipes.

2. Do not allow the gas cylinder to reach a temperature of 40 °C or more at any time. Do not allow any open flame to

come within 2 m of the cylinder.

3. When using high-pressure gas, pay special attention to ventilation and use soapy water or other methods to inspect for

leaks before initial operations. In particular, do not smoke or permit open flames within 5 m of any equipment using

combustible gases. Have an effective fire extinguisher ready.

4. Secure cylinders with rope or by other means to prevent them from tipping or falling over.

5. Use a pressure release valve designated as oil-less. Do not use valves with oil adhered to the inner surfaces of piping

or other areas that come into contact with the gas.

6. Close the main cylinder valve immediately when finished using the cylinder.

Need help?

Do you have a question about the Shimadzu LCMS-8045 and is the answer not in the manual?

Shimadzu LCMS-8045 Specifications

General

Type	Triple Quadrupole Mass Spectrometer
Software	LabSolutions
Heated ESI Probe	Yes
Ionization Method	Electrospray Ionization (ESI), Atmospheric Pressure Chemical Ionization (APCI)
Mass Range	10 to 2000 m/z
Scan Speed	15, 000 u/sec
Data Acquisition	MRM, SIM, Scan, Product Ion Scan, Precursor Ion Scan, Neutral Loss Scan
Polarity Switching Time	5 msec
Resolution	Unit mass resolution
Mass Accuracy	0.1 Da
LC Flow Rate	0.1 to 2.0 mL/min
Power Requirements	AC 100-240V, 50/60 Hz