Shimano Steps E6000 Series - Method of Use; Introduction and Initial Charging

Installation
Installing the cycle computer
12
 Installing the cycle computer
1
Open the clamp (B) and attach it to the handlebar.
2
Attach and tighten the handlebar fixing
bolt (A) with a screwdriver.
(A)
(B)
(C)
(A) Handlebar fixing bolt
(B) Clamp
(C) Adapter
Handlebar compatibility table
øA øB-øA Adapter Fixing bolt
ø23.4-ø24 0-1.1 X 15.5mm
ø24-ø25.5 0-1.1 X 20mm
ø31.3-ø31.9 0-0.6 - 20mm
*X: OK
Handlebar
øA øB
25
30
When removing the cycle computer, reverse
the procedure.
Tightening torque:
1 N·m
{9 in. lbs.}