Shimano Steps E6000 Series - Powering the System On;Off

Installing and wiring the drive unit
Connecting the speed sensor to the drive unit
To be continued on next page
25
 Connecting the speed sensor to the drive unit
Connect the speed sensor unit electric wire to the drive unit speed sensor connector (B) using the
TL-EW02 (A).
(A) TL-EW02
(B) Speed sensor connector
(A)
(B)
 Connecting the light adapter to the drive unit
To connect the light using the light adapter, carry out wiring as follows.
(A)
(A) Light adapter
1
Attach the light adapter (A) in the
direction shown in the illustration.
Secure it to the drive unit with the unit
fixing screw (B).
(A)(B)
(A) Light adapter
(B) Unit fixing screw
Tightening torque:
0.6 N·m
{5.3 in. lbs.}