Why are my Shimano Steps Camera Accessories battery and charger getting so hot?
If the Shimano Steps Camera Accessories battery and battery charger become hot, the temperature of the battery and battery charger may exceed the operating temperature. Stop charging, and wait a while before starting to charge again.
Why doesn't the LED light up on my Shimano Steps Camera Accessories battery?
If the Shimano Steps Camera Accessories battery LED does not light up, it may be because the battery level has been at 0% for a long time, or the battery hasn't been charged after purchase. Charge the battery.
How to fix Shimano Steps Camera Accessories when it cannot charge?
If your Shimano Steps Camera Accessories cannot charge, first, check the power plug of the battery charger. Remove and reconnect it securely, and then try charging again. Next, verify the charging plug of the battery charger is securely inserted into the battery by removing and reconnecting it. Also, check that the charging adapter and charging plug or charging adapter and battery charging port are securely connected. Finally, inspect the connection terminals of the battery charger, charging adapter, or battery for dirt. Clean them with a waste cloth or cotton bud dampened with ethanol, and then try charging again.
What to do if the LED lights up briefly but my Shimano Steps Camera Accessories doesn't power on?
If you press the satellite power button and the LED lights up briefly but the power doesn't turn on for your Shimano Steps Camera Accessories, the (main) battery level might be too low. Try charging the (main) battery. Also, check that the (main) battery is securely connected.
Why is the LED light off on my Shimano Steps Camera Accessories battery charger?
If the Shimano Steps Camera Accessories battery charger LED does not light up, check the charging plug. Ensure no foreign material is attached to the connection area. Remove and reconnect the charging plug. Also, the LED turns off when the battery is fully charged; this is normal. Remove and reconnect the power plug of the battery charger, and then charge again.
Why does my Shimano Steps Camera Accessories battery drain so fast?
If the Shimano Steps Camera Accessories battery depletes quickly, it could be that the battery has reached the end of its life. In this case, replace the battery with a new one. Alternatively, the battery's temperature might be outside of its operating range. Ensure you use the battery within its specified operating temperature range.
What does it mean if my Shimano Steps Battery Charger repeatedly flashes 3 times, indicating the temperature exceeds the operating range?
If the temperature is higher than the temperature at which discharging is possible, leave the Shimano Steps battery in a cool location with no direct sunlight until the internal temperature of the battery has decreased sufficiently. If the temperature is lower than the temperature at which discharging is possible, leave the battery indoors until the internal temperature has increased to an appropriate temperature.
General| Brand | Shimano Steps |
|---|---|
| Model | EW-SW100 |
| Category | Bicycle Accessories |
| Language | English |
Safety precautions for battery handling, including charging, heat, modification, and short circuits.
Safety precautions for battery charger handling, including water, power supply, and modifications.
Precautions about wet conditions, temperature ranges, and physical damage to the battery.
Precautions about electrical outlets, power cords, and using transformers.
Precautions about sunlight, heat, children, and handling components.
Precautions about charging temperature and skin contact.
Table showing charging times for different batteries and chargers from 0% to full.
Lists symptoms, causes, and remedies for common issues.
Details error indications for five-LED battery lamps.
Details error indications for single-LED battery lamps.
To Next Page
