Shimano Steps SC-E6000 - Installing and Removing the Cycle Computer; Adjusting the Angle of the Cycle Computer

Installation
Installing and removing the cycle computer
13
 Installing and removing the cycle computer
1
Slide the cycle computer (A) into the
bracket (B) as shown in the illustration.
Insert it firmly until you hear it click.
(A)
(B)
(A) Cycle computer
(B) Bracket
2
To remove the cycle computer, slide it
while pushing the bracket lever (C).
(C)
(C) Lever
NOTE
If the cycle computer is not in the correct
place, the assist function will not operate
normally.
 Adjusting the angle of the cycle computer
Loosen the angle adjustment screw (A) with a
screwdriver. Adjust the angle of the cycle
computer to make it easier to see while riding.
After determining the angle, tighten the screw
to the designated torque.
(A)
(A) Angle adjustment screw
Tightening torque:
0.5 N·m
{4.4 in. lbs.}