Shimano Steps SC-E6000 - Error Messages on the Cycle Computer

Cycle Computer Display and Setting
Error messages on the cycle computer
48
 Error messages on the cycle computer
WARNING
This disappears if the error is fixed.
A message appears instead of the clock indication.
List of warnings
Code
Situation where the
error occurred
Operational restrictions when
a warning is being displayed
Remedy
W010
The temperature of the
drive unit is high.
The level of assistance may
decrease.
Stop using the assist function until the temperature of the drive unit
drops.
If the situation does not improve, consult an agency.
W011
The traveling speed
cannot be detected.
The maximum speed up to
which power assistance is
provided may decrease. (Power
assistance is provided up to 25
km/h in top gear.)
Check that the speed sensor is properly installed.
If the situation does not improve, consult an agency.
W030
Two or more assist
switches are connected
to the system.
Gear shifting is not available for
power gear shifting derailleurs.
Change the assist switch to the gear shifting switch, or connect only
one assist switch and turn on the power again.
If the situation does not improve, consult an agency.
-
A communication error
between the drive unit
and the motor unit was
detected.
Gear shifting is not available for
power gear shifting derailleurs.
Check that the cable is properly connected between the drive unit and
the motor unit.
If the situation does not improve, consult an agency.