Installing and wiring the drive unit
Connecting the electric wire
24
Connecting the electric wire
1
Set so that the projection on the
connector is aligned with the groove on
the narrow end.
(B)
(A)
OK Not OK
(A) TL-EW02
(B) Plug
NOTE
Use the Shimano original tool for installation
and removal of the electric wire.
When installing the electric wire, do not
forcibly bend the plug.
It may result in a poor contact.
When connecting the electric wire, push it in
until it clicks in place.
Connecting the assist switch and drive unit to the cycle computer
Use the TL-EW02 (D) for connection.
(A) Cycle computers
(B) Assist/Shift switch
(C) Drive Unit
(D) TL-EW02
The electric wire connector can be connected to any port of
the cycle computer, but we recommend you connect the
assist switch to the switch-side port.
(A)
(C)
(B) (B)
(D)
To Next Page
Loading...
