51
Connection and communication with the PC
Connection and communication with the PC
You can connect the bicycle (system or components) to a PC via a PC linkage device to carry out tasks such as customizing single components or the whole
system and updating their fi rmware.
You need E-tube Project to confi gure SHIMANO STePS and update fi rmware. Download E-tube
Project from our support website (http://e-tubeproject.shimano.com).
For information on how to install an E-tube project, check the E-tube support website. For
information on how to use E-tube Project on your PC, refer to the help manual for E-tube Project.
NOTE
You need SM-PCE1 and SM-JC40/JC41 to
connect SHIMANO STePS to a PC. They are not
required if there is an available port.
Firmware is subject to change without notice.
To Next Page
Loading...
