Connection and communication with the PC
Settings customizable in E-tube Project
52
Settings customizable in E-tube Project
Switch function setting
Changes the functions to assign to switches X, Y, and Z of SW-E6000 or switch X and Y of SW-S705.
Functions that can be assigned vary depending on the type of switch.
•
SW-E6000 : The same function cannot be assigned to different switches.
•
SW-S705 : The same function can be assigned to different switches.
Switch mode setting Sets SW-E6000 to be used for either assist mode switching or gear shifting.
Drive unit
setting
Light Sets whether to use a light.
Start mode Switches the start mode on or off. You can change gear position when on is selected.
Display
monitor
setting
Display units Switches the display unit between km and mile.
Time setting Sets the time.
Backlight setting Switches the backlight of the cycle computer on or off.
Beep setting Switches the beep sound on or off.
Display language You can choose from English, French, German, Dutch, Spanish, and Italian.
Traveling time Switches the traveling time indication on or off.
Average speed Switches the average speed indication on or off.
Maximum speed Switches the maximum speed indication on or off.
Range overview Switches the traveling range list indication on or off.
Motor unit gear setting Switches MU-S705 between the 8-speed and 11-speed setting.
Other functions
•
Error check
•
Update firmware
•
Preset
•
Unit log acquisition
•
Motor unit adjustment (MU-S705)
*
For details, download E-tube Project and refer to the manual provided.
To Next Page
Loading...
